SMC EliteConnect Wireless Bridge Guia do Utilizador descarregar pdf (Página 50)

Initial Configuration

5-2

For a description of how to use the CLI, see “Using the Command Line Interface” on

page 7-1. For a list of all the CLI commands and detailed information on using the

CLI, refer to “Command Groups” on page 7-6.

Initial Configuration Steps

Logging In – Enter “admin” for the user name. The default password is null, so just

press [Enter] at the password prompt. The CLI prompt appears displaying the

access point’s name.

Setting the IP Address – By default, the access point is configured to obtain IP

address settings from a DHCP server. If a DHCP server is not available, the IP

address defaults to 192.168.2.2, which may not be compatible with your network.

You will therefore have to use the command line interface (CLI) to assign an IP

address that is compatible with your network.

Type “configure” to enter configuration mode, then type “interface ethernet” to

access the Ethernet interface-configuration mode.

First type “no ip dhcp” to disable DHCP client mode. Then type “ip address

ip-address netmask gateway,” where “ip-address” is the access point’s IP address,

“netmask” is the network mask for the network, and “gateway” is the default gateway

router. Check with your system administrator to obtain an IP address that is

compatible with your network.

After configuring the access point’s IP parameters, you can access the management

interface from anywhere within the attached network. The command line interface

can also be accessed using Telnet from any computer attached to the network.

Username: admin

Password:

SMC Enterprise AP/Bridge#

SMC AP#configure

SMC AP(config)#interface ethernet

SMC AP(config-if)#

SMC AP(if-ethernet)#no ip dhcp

SMC AP(if-ethernet)#ip address 192.168.2.2

255.255.255.0 192.168.2.254

SMC AP(if-ethernet)#

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 317 318

Sem comentários

SMC EliteConnect Wireless Bridge Guia do Utilizador Página 50